Matters Needing Attention In Flat Bed CNC Lathe Machining

CNC lathe making a part (also known as a work piece) doesn't usually start on a CNC machine -- it starts much earlier on a design engineer's desk. Engineering design means developing an intended part that is inexpensive to manufacture and of high quality, and a part that does what it's supposed to do - simply, designing a part that works. This process takes place in various offices and laboratories, research centers and elsewhere, including in the imagination of engineers.

Common CNC Lathe Machining Problems

1. Flat bed CNC lathe so-called "speeds and feeds" are only part of the overall cutting conditions. Cutting conditions are affected by many fixed factors, such as the material being machined, its shape and condition, machine performance, etc. They are also affected by the conditions of the CNC programmer's capabilities - for example, tool selection, setup method, depth of cut, width of cut, spindle speed and cutting feed rate.

2. Automatic CNC lathe machine tool selection is also part of the programming process, and experienced programmers often discuss tool possibilities with CNC operators. Choosing a tool for CNC machining means choosing:

cutting tool holder

cutting tools

2. The mini CNC lathe checks that the hydraulic pump and hydraulic pressure are properly set.

3. CNC machining parts clamping

Parts holding - or job holding - is a subject that could have its own book. From the CNC perspective, the decision that the CNC programmer must make is to choose such a method of work holding that provides a fixed, secure, and stable position for the mounting material.